Filter
Top Products
162
1745D–ATARM–04-Nov-05
AT91M55800A
• Software Trigger: Each channel has a software trigger, available by setting SWTRG in
TC_CCR.
• SYNC: Each channel has a synchronization signal SYNC. When asserted, this signal has
the same effect as a software trigger. The SYNC signals of all channels are asserted
simultaneously by writing TC_BCR (Block Control) with SYNC set.
• Compare RC Trigger: RC is implemented in each channel and can provide a trigger when
the counter value matches the RC value if CPCTRG is set in TC_CMR.
The Timer Counter channel can also be configured to have an external trigger. In Capture
Mode, the external trigger signal can be selected between TIOA and TIOB. In Waveform
Mode, an external event can be programmed on one of the following signals: TIOB, XC0, XC1
or XC2. This external event can then be programmed to perform a trigger by setting ENETRG
in TC_CMR.
If an external trigger is used, the duration of the pulses must be longer than the system clock
(MCK) period in order to be detected.