Filter
Top Products
143
1745D–ATARM–04-Nov-05
AT91M55800A
18.10.1 USART Control Register
Name: US_CR
Access Type: Write-only
Offset: 0x00
• RSTRX: Reset Receiver (Code Label US_RSTRX)
0 = No effect.
1 = The receiver logic is reset.
• RSTTX: Reset Transmitter (Code Label US_RSTTX)
0 = No effect.
1 = The transmitter logic is reset.
• RXEN: Receiver Enable (Code Label US_RXEN)
0 = No effect.
1 = The receiver is enabled if RXDIS is 0.
• RXDIS: Receiver Disable (Code Label US_RXDIS)
0 = No effect.
1 = The receiver is disabled.
• TXEN: Transmitter Enable (Code Label US_TXEN)
0 = No effect.
1 = The transmitter is enabled if TXDIS is 0.
• TXDIS: Transmitter Disable (Code Label US_TXDIS)
0 = No effect.
1 = The transmitter is disabled.
• RSTSTA: Reset Status Bits (Code Label US_RSTSTA)
0 = No effect.
1 = Resets the status bits PARE, FRAME, OVRE and RXBRK in the US_CSR.
• STTBRK: Start Break (Code Label US_STTBRK)
0 = No effect.
1 = If break is not being transmitted, start transmission of a break after the characters present in US_THR and the Transmit
Shift Register have been transmitted.
• STPBRK: Stop Break (Code Label US_STPBRK)
0 = No effect.
1 = If a break is being transmitted, stop transmission of the break after a minimum of one character length and transmit a
high level during 12 bit periods.
31 30 29 28 27 26 25 24
– – – – – – – –
23 22 21 20 19 18 17 16
– – – – – – – –
15 14 13 12 11 10 9 8
– – –
SENDA STTTO STPBRK STTBRK RSTSTA
7 6 5 4 3 2 1 0
TXDIS TXEN RXDIS RXEN RSTTX RSTRX
– –