Filter
Top Products
LTR-Net PROGRAMMER
4-10
March 1999
Part No. 001-2009-600
4.5.6 MODE SELECT
The Mode Select window places the repeater
either in the Normal mode, Test mode or Diagnostic
mode. In the Normal mode, the repeater operates as a
normal repeater. In the Test mode or Diagnostic Mode
the repeater transmits a test word. This test word is
the Test Mode ID setup in the Repeater Information
(see Section 4.3.3
).
C A U T I O N
While in the test or diagnostics mode the repeater is
"Busy", therefore it is important to place the repeater
in Normal mode when the Test Mode is no longer
required.
Figure 4-23 MODE SELECT
Figure 4-24 TEST PROGRAMMING FLOWCHART
PA
Receiver
Exciter
TEST
Full Repeater
Adjust Switch Link
All Tests
Repeater Setup
Transmitter Test
Receiver Test
Transmit Audio/Data
Audio Data Adjust
Repeater Operations
4.6 TEST
Figure 4-25 TEST MENU
NOTE: Some screens may require scrolling down to
read the complete procedure.