Filter
Top Products
Initialization & Test
Program 00 – Part 2: Processor RAM Test
2-16 Strata DK Programming 5/99
Display Backup RAM Test Results
Program 00 Part 2 - Overview
Use this program to test the RAM on system processor. If a RAM test error occurs during this test,
the processor causing the error should be replaced. In the case of two-PCB processors, isolation of
a RAM failure is indicated on the programming telephone X or Y (see above).
If the DK14 or DK40i processor fails the RAM test, the Base KSU must be replaced.
CAUTION! Running each RAM test drops all calls and interrupts telephone service for 15
seconds.
Note Running Program 00 RAM tests do not change or erase any customer data.
Programming Telephone LCD Displays:
DK424 DK14/DK40i
TEST 2 X=OK Y=OK TEST 1 =OK
or... or...
TEST 2 X=NG Y=NG
X=00000 X=00000
TEST 2 =NG
Where:
X = RCTUA, RCTUBA, RCTUC
Y = RCTUD3, RCTUF
OK = RAM is good
NG = RAM is defective
An
X=NG or Y=NG RAM test result indicates a defective RCTU PCB; change
the appropriate (X or Y) RCTU PCB and retest RAM on the newly installed
RCTU.
Replace the DK14 or DK40i Base KSU if
Test 1=NG.