Filter
Top Products
Toll Restriction
Program *45-4 – Special Code Dialing Sequence with LCR
4-28 Strata DK Programming 5/99
Program *45-4 – Special Code Dialing Sequence with
LCR
Processor Type:
DK424, all RCTUs (Release 4.1 and higher)
Program Type:
Toll Restriction and LCR
Initialized Default:
All LEDs OFF
Program *45-4 Overview
When LCR is used to make calls, this program determines if the codes set in Program *45-3 are
sent before or after the digits that are set in the modified digits table (MDT). See Programs 55-1
and 55-0.
Program *45-4 only works when the code of Program *45-3x is dialed. The length of the pause
inserted is determined by the timer setup in Program 12-3 (unit pause length of 1.5 or 3 seconds).
This program has no effect on outgoing calls without Program *45-3 codes.
The digit deletion function of the modified digits table (Program 55-0) applies to the digits that
immediately follow the Front Modified Digits Table (F-MDT).
LED 01: Pause following Program *45-3 code
If LED 01 is ON, a pause is inserted after the digits from Program *45-3 are sent; if LED 01 is
OFF, a pause is not inserted.
LED 02: Order of LCR bypass code and MDT
If LED 02 is ON, the code from Program *45-3 is inserted before the Front Modified Digits Table
(F-MDT) digits; if LED 02 is OFF, code from Program *45-3 is inserted after the
F-MDT digits. (See example on Page -28.)
If LED 02 is ON, digits are not deleted from the Program *45-3 code per Program 55-0; if LED 02
is OFF, digits are deleted from the Program *45-3 code per Program 55-0.
LCR Example
The table below shows the actual dial output digits at the time that LCR sends them. These output
digits are determined by the settings for LEDs 01 and 02. In this example, the user dials
+ code
+ telephone number.
Button/LED X
LED ON LED OFF
20~3 Not used. Not used.
02 Sends the digits from Program *45-3 before
the Programs 55-1 Modified Digits Table
(MDT) digits.
Sends the Programs 55-1 Modified Digits Table
(MDT) digits before the digits from Program *45-
3.
01
Inserts a pause into the dialing sequence.
Does not insert a pause into the dialing
sequence.
SELECT = 4 Light the LED Buttons that are
marked with an X in the table below.