Toshiba DK14 Answering Machine User Manual


  Open as PDF
of 418
 
System & Station
Program 33 – [PDN]/ [PhDN] Station Hunting (Voice Calls Only)
Strata DK Programming 5/99 3-91
System & Station
On Ring-first systems, if a [PDN] appears on more than one button (on owner’s telephone), the
DK will not hunt until all appearances of the [PDN] are in use.
On Voice-first systems, the system will hunt for an available station if any one of the [PDN]
appearances is busy.
Program 33 - Example
Action (press buttons+LED buttons) LCD Response
1. Use the programming LCD electronic or digital telephone connected to
physical port 005 - circuit 6.
Make sure the programming button strip template is installed on the
programming telephone. (See “Program 38 Digital and Electronic
Telephone Keystrip Type” on Page 3-109.)
No. N-N
1
Jan 20 Sun 06:43
1. N-N = Program telephone [PDN]
2.

Enter programming mode. (Do not press [DN] button.)
Program Mode
3. 6SNU6SHDNHU+ROG
Access Program 33. System beeps after 6SNU6SHDNHU  is pressed
to indicate program number may be entered.
Program = 33
Data Store
4. 6SNU6SHDNHU
Prepare the system for a station port selection.
33 Select =
5. ~ or ~
Select the port number of the Hunt From station. A range of ports can
be entered as specified on the record sheet. After the Hunt From port
is entered, press the button. Do not press when entering a range.
33 Select = (000~335)
Hunt To =
6. ~ or ~
Enter the port number of the Hunt To point, as recorded on the system
record sheet. Press LED button 01 to delete a digit from Hunt To point
ports.
33 Select = (000~335)
Hunt To = (000~335)
7. +ROG
Secure data in system programming.
33 Select = (000~335)
Data Programmed
8. 6SNU6SHDNHU
Prepare system for another selection (go back to Step 5), or exit
Program 33 (continue with Step 9).
33 Select = ##
9. +ROG
Secure Program 33 data in system memory.
33 Select =
Data Programmed
10. 6SNU6SHDNHU
Exit Program 33. Enter another program number or exit programming
mode (go to Step 11). Speaker beeps to indicate it is exiting
Program 33.
Program =
11. +ROG
Exit programming mode.
No. N-N
Jan 20 Sun 06:58
 previous next