Filter
Top Products
Toll Restriction
Program 42-1~8 – PBX/Centrex Access Codes
4-10 Strata DK Programming 5/99
Program 42-1~8 – PBX/Centrex Access Codes
Processor Type:
DK14, DK40i, All RCTUs
Program Type:
Toll Restriction
Initialized Default:
Assigns no access codes to PBX groups
Program 42-1~8 Overview
The Centrex access code(s) used to make out-of-centrex calls (usually 9) is entered in this table.
Use this program to allow correct Toll Restriction and Centrex/PBX transfer operation.
Do not use this program when using LCR behind Centrex/PBX; use Program 45-2 instead. Also,
do not use this program if installing CO lines behind “assume-9” Centrex.
PBX/Centrex Access Code
Number
PBX/Centrex Outgoing CO Line Access Code(s)
1st Digit 2nd Digit
1
2
3
4
5
6
7
8
ACCESS CODE = Enter a 2-digit access code for the group,
as defined by the table below.
• If access code is single digit, enter the first digit and press
LED Button 01 as second digit.
• Press LED Button 01 to delete digit.
• Press LED Button 02 for Wild Card digit (any digit, 0~9). For
example, pressing
+ LED Button 02 allows 80~89.
SELECT = 1~8 PBX Access Code Group
Enter the PBX Group Number 1~8 that needs
an access code assigned.