Filter
Top Products
ISDN
System Programs Overview
7-2 Strata DK Programming 5/99
Flowchart 7-1 ISDN System Programs
➤ To record and enter the data for ISDN system programs
1. Run Program 03-Assign the RPTU (PRI) PCB slot position as type 79. (See “Program 03 for
DK424 – Flexible PCB Cabinet Slot Assignments” on Page 3-6.) Assign the RBSU without
the RBSS piggy-back board as type 77 and the RBSU with the RBSS piggy-back as type 78.
2. For BRI, run Program *60 to assign each circuit for CO line (TE) or Station (NT) operation.
3. Turn system power supply OFF (five seconds) and ON to activate Program 03 and *60
program data.
Note These are the only programs relating to RPTU operation that require system power to be
cycled OFF and ON.
4. For PRI, run Program *43 to assign which channel on the PRI link is used for the
D-channel. The second assignment specifies the card slot of additional PRI links that are
dependent on the master D-channel PRI. The third assignment sets the ID code for the PRI
link. For BRI, skip to Step 5.
*41 T1 Assignments
*42 Clock Source
Program *60
Assign BRI circuits
for CO line (TE)
or Station (NT)
operation.
System power must cycle OFF and ON to effect changes.
T1 BRIPRI
Program 03
Assign BRI or
PRI card slots.
Program *43
Assign the PRI
D-channel and
network interface.
Program *44
Initialize BRI
Service Profile ID
(SPID) number.
*42 Clock Source
Program *63
Set ISDN dialing
timers.
2934