Filter
Top Products
Least Cost Routing
Program 50-1 – LCR Parameters
5-4 Strata DK Programming 5/99
Program 50-1 – LCR Parameters
Processor Type:
DK14, DK40i, All RCTUs
Program Type:
Least Cost Routing
Initialized Default:
All LEDs OFF
Program 50-1 Overview
This program defines general operating parameters for LCR software.
● Program 40 denies CO line access via LCR, but denies all other access methods.
● Program 41 allows CO line access via LCR, but denies all other outgoing access methods:
(#7001~#7200, 801~816, Line button).
● Toll Restricted standard telephones should be forced to dial outgoing calls via LCR. This is to
prevent Toll Restriction defeat when the QRCU3, K4RCU3, K5RCU or RRCS times out.
LED 01: Enable System LCR
LED 01 ON: LCR software is enabled system-wide. For the Hospitality Management Information
System (HMIS), this LED must always be set to ON.
LED 01 OFF: LCR software is disabled. None of the LCR programming referred to by this section
is recognized. Dial 9 access assigned in Program 16 is enabled.
LED 02: Not used
LED 03: 555 LDI Route Per Program 50-4
LED 03 ON: LCR routes long distance information (LDI) calls over the plan number specified in
Program 50-4.
LED 03 OFF: LCR routes LDI calls using area codes specified in route plans in the following
table, as it would for any other call.
LED ON OFF
01 Enable System LCR No LCR
02 Not Used Not Used
03 555 LDI Route per Program 50-4 Per Area Code Table
04 Dial Tone After LCR Access Silent
05 Warning Tone Last Choice Route Number No Warning Tone
10 No CO Dial Tone After Line Access CO Dial Tone (R4.15)
Processor
Route Plans
Supported
Processor
Route Plans
Supported
DK14 8 RCTUBA/BB 8
DK40i 8 RCTUC/D 16
RCTUA 8 RCTUE/F 16
Press LED Buttons for each LCR parameterSELECT = 1