Filter
Top Products
Initialization & Test
Program 92 – Initializing Misc. Backup RAM
2-10 Strata DK Programming 5/99
● Program 92-9 does not affect Call Forward External or Fixed Call Forward settings.
● You must power the system OFF then back ON to clear telephone LCD Call Forward Displays
and Call Forward button LEDs. Call Forward memory is cleared when you run Program 92-9,
even if system power is not cycled.
Program 92 Example
Action (press buttons + LED Buttons) LCD Response
1. Use the programming LCD electronic or digital telephone. (See “Step
1: Check Minimum Hardware Requirements” on Page 1-14.)
No. N-N
1
Jan 20 Sun 06:43
2.
Enter programming mode. (Do not press [DN] button.) System beeps
after
6SNU6SHDNHU is pressed to indicate program number may
be entered.
Program Mode
3.
6SNU6SHDNHU+ROG
Access Program 92.
Program = 92
Data Store
4. 6SNU6SHDNHU
Prepare the system for selection of programs to initialize. For new
system installation perform all 1~4.
92 Select =
5.
Select one of the following.
+ LED Buttons 01 & 03
Clears Station Speed Dial, Voice Mail ID codes, and LCD memos
assigned to station speed dial numbers.
92 Select = 1
Each Dial Clr
or...
+ LED Buttons 01 & 04
Clears System Speed Dial and LCD memos assigned to system
speed dial numbers.
92 Select = 2
Common Dial Clr
or...
+ LED Buttons 02 & 03
Clears Character Message Memory (station and system) and user
name display.
92 Select = 3
Msg Clr
or...
+ LED Buttons 02 & 04
Clears timed reminders.
92 Select = 4
Tmr Reminder Clr
or...
+ LED Buttons 01 & 05
Presets the Ring, Speaker, Mute Ring, and Intercom Tone, BGM,
volume levels of all digital telephones to approximately mid-range.
92 Select = 5
DKT VR Initial
or...
+ LED Buttons 03 & 04
Clears Call Forward and Message Waiting (R3) Memory except Fixed
Call Forward Memory.
92 Select = 9
Back Up RAM Clr
6.
+ROG
LEDs lit in Step 5 turn off to secure data in system programming.
Repeat Steps 4~6 until Step is completed.
92 Select = (1~0)
Data Programmed
1. N-N is the Program Telephone [DN].