Filter
Top Products
System & Station
Program 30 – Station Class of Service
Strata DK Programming 5/99 3-75
System & Station
LED 16: Change Toll Restriction Traveling Class Code
When LED 16 is ON for a port, the station occupying it can change the four-digit Toll Restriction
Traveling Class of Service Codes established in Program 44-1~8. Stations selected for this feature
must follow the dialing sequences below to change the codes:
LED 15: Change Verified Account Code
With LED 15 ON, a station can change the Verified Account Codes established in Program 69.
Selected stations must dial the following sequence to change the codes:
[PDN] +
+ Verified Account Code + Redial:
Press
button if your electronic telephone does not have a 5HGLDO button.
Total Account Code digit length is set in Program 10-4 (up to 15 digits). All digits do not have to
be verified.
LED 14: Verified Account Code
With LED 14 ON, the system verifies all Forced or Voluntary Account Codes (set in Program 69)
dialed by the station user. If the station user does not dial a specific Verified Account Codes, the
call does not execute (Forced), or the Account Code is not validated for the SMDR call report
(Voluntary).
To force a verified account code entry on Two-CO line DISA calls through the system, turn LED
08 and 14 ON for Port 10-DK14, Port 035-DK40i, Port 039-RCTUA, Port 089-RCTUB,
RCTUBA/BB or Port 249-RCTUC/D or Port 344-RCTUE/F. Also, you must enable Forced
Account Code for outgoing CO line in Program 15-7.
LED 12: Single Line Telephone (SLT) Hookflash Anti-bounce Guard
SLT Hookflash Anti-Bounce Guard (LED 12 ON) prevents false recalls due to hook flash bounce
during SLT hang-up on outside calls. The system automatically disconnects the CO line if the SLT
hangs-up after a Hook Flash.
Use for QSTU2, PSTU, RSTU, RSTU2, RDSU, PESU, and KSTU2 standard telephone ports that
have standard telephones (with/without message lamps) connected to them to prevent false ring
signals. With this option ON, a CO line connected to a standard telephone is disconnected if the
standard telephone user hookflashes and then hangs up. If this option is OFF, the CO line recalls
the standard telephone.
LED 11: Dial Pulse - Dual-tone Multi-frequency (DTMF) OFF
Use Dial Pulse - DTMF OFF (LED 11 ON) if any device, DID or Tie line station port does not
require the RRCS, K5RCU, K5RCU2, or K4RCU for DTMF decoding. When the device goes off-
hook or the DID or Tie line is seized for an incoming call, the DTMF receiver is not accessed -
reducing unnecessary traffic to it.
Class 1 #691 Class 5 #695
Class 2 #692 Class 6 #696
Class 3 #693 Class 7 #697
Class 4 #694 Class 8 #698
[PDN] + class code ( ~ ) +four-digit code +
System Verified Account Code
RCTUE/F 000~499
RCTUA, BA/BB, C/D, DK40i, DK14 000~299