Filter
Top Products
203
Routine Maintenance
Performing Backups
Backing Up a Database
The controller has three databases, one for CDE data, one for voice mail data
(includes configuration, greetings, and user messages) and one for IP
networking settings. All databases are maintained in flash memory (or on the
hard drive, if installed) inside the controller. An FTP server is required to back
up the databases. For information on setting up an FTP server, see page 75.
It is recommended that you back up the database:
• after the system is first installed and the database is set up
• after changes have been made to the database
• before any software upgrades.
Before starting the backup, ensure that the FTP destination directory is
writable (i.e., not read-only). Also, check that the FTP server IP address,
username, and password in Form 47 are correct.
To back up the database:
1. Log in to the Maintenance Terminal (direct, secure Telnet, or SX-200
ICP Web Interface) and begin a Maintenance session.
2. Press
SYSTEM
DATABASE
BACKUP
FTP_SERVER
FULL or MEDIUM
CONFIRM (enter a a file name)
CONFIRM
FULL backs up everything; MEDIUM excludes voice mail messages.
Full backups are recommended.
The system creates a backup to the specified FTP home directory.
Note: Database backups do NOT include log files and trap files. Mitel
Technical Support may request these files should you call for assistance; see
““Sending Logs and other System Files to an E-mail Address or FTP Server”
on page 233” for more information.
Note: Voice mail is unavailable while the backup is progress.