Filter
Top Products
120
SX-200 ICP MX Technician’s Handbook
5. To connect the PC to the NSU, connect an RS-232 straight DTE serial
cable between the NSU’s serial port and the PC’s serial port.
To create a Dial-Up Network connection on Windows 95/98:
1. Click the Start button, select Programs, Accessories, then Dial-Up
Connections.
2. Double-click Make New Connection.
3. Enter an appropriate name for the connection (for example, Direct for
direct connections, Remote or a customer’s name for remote
connections) and click Next.
4. Enter an Area Code and Telephone Number and select a Country
Code from the drop-down list. Click Next.
5. Click Finish.
6. Right-click your new connection icon and click Properties.
7. Click Configure. Ensure the fields are set as follows:
Data bits: 8
Parity: none
For a direct connection:
Maximum speed: 38400
Check: only connect at this speed.
Select wait for dial tone before dialing.
Select cancel the call time at 60 seconds.
Click Advanced and turn off error control and flow control.
For a remote connection:
- Stop bits: 1
Note: If you are connecting through a modem, use a null modem adapter on
the NSU side.
Note: You might need to do this procedure twice to create two Dial-up
Networking connections: one for on-site direct access, and one for remote
modem access.
Note: Even though it is not needed for a direct connection, Windows requires
that you enter this information.
Note: If you are creating a direct connection, make sure NT Direct Connection
is listed in the drop-down list in the Make a New Connection window.