Filter
Top Products
158
SX-200 ICP MX Technician’s Handbook
Programming with MyAdministrator
The SX-200 MyAdministrator software application is used to perform basic
changes to telephone and voice mail programming. It is also used to gather
and display IP voice networking statistics related to IP trunk performance,
delays during peak periods, and outages in the network.
The application software is the MyAdmin folder on the SX-200 ICP
software CD. Run Setup.exe to install it.
MyAdministrator can manage the following device types:
• All Mitel IP Phones, and sub-attendant variants of the 5020, 5220,
5220 Dual Boot, and 5224 Dual Boot IP Phones
• Mitel 5310 IP Board Room Conference Unit (shown as 5020 IP
Phones)
• ONS Stations
• SUPERSET 401 and 4001 (key programming is not supported)
• SUPERSET 410, 4105, 420, 4025, and 4125, 430, 4150, and their
subattendant variants
• Programmable Key Modules
• SpectraLink NetLink e340, h340 and i640 Wireless Telephones
The application identifies but cannot program the following devices:
• PKM Interface Unit (DSS/BLF Interface Unit)
• SUPERSET 3DN and 4DN telephones
• DMP Units.
Requirements
• The SX-200 ICP requires purchasable System Option 80,
MyAdministrator Access.
• A PC running Microsoft
®
Windows
®
98, Windows 2000 Professional,
Windows ME, a Windows NT 4.0 Workstation (Service Pack 4.0 or
greater), or Windows XP.
• A LAN connection for the PC. Direct and modem connections to the
SX-200 ICP are not supported.
Note: The SX-200 ICP supports MyAdministrator Release 3 and higher only.