Filter
Top Products
105
Basic Programming
Programming a Printer Port
System Printer Port
• Form 34, Directed I/O
- Program the printer port in Form 34.
- Define Printout Types that are to be delivered to the system printer
port.
- Remove printer port for print types not used.
- Speed of printer port is programmed in Maintenance. Defaults:
Baud Rate: 300
Stop Bits: 1
Data Bits: 8
Flow Control: None
Parity: None
Dataset Printer Port
1. Form 11, Data Circuit Descriptor
- Define a circuit descriptor to match characteristics of device type.
Refer to Form 04, System Options and Timers on page 133 for
typical circuit descriptor.
2. Form 12, Dataset Assignment
- Assign the type of data device for the dataset PLID. Available types
are DSCONS Console (output only, maximum 2400 baud) and
1103/2103 Standalone dataset.
- Assign a Tenant, Extension number, COS, COR, and circuit
descriptor number.
3. Form 34, Directed I/O
- Define printout type to be delivered to the dataset.
Note: Printer ports only work on the SX-200 ICP controller, not on Peripheral
cabinets.