Filter
Top Products
112
SX-200 ICP MX Technician’s Handbook
Programming an Analog Device to a SIM2
(DNIC Phones Only)
The analog interface in the SIM2 supports devices such as analog
telephones, fax machines, or modems. The SUPERSET provides the
power to the analog interface.
Ensure that the set firmware revision level matches the system firmware
revision level. If the revision level on the system is higher than the set
revision level, upgrade the set firmware.
Refer to Upgrading Set Firmware (page 216).
When adding an analog set to a SIM2, use Form 12 to program the port.
The port type is AIM.
Programming an NSU or a PRI Card in a
Peripheral Cabinet
The NSU and PRI card support the following purchasable MOSS options:
QSIG (option 86), NFAS (option 91), D-Channel Backup (option 92),
Remote LAN Access (option 93), Min/Max (option 94), Auto Min/Max
(option 95), Number of Links 0-8 (option 96).
Option 91 to 95 are downloaded to each NSU and PRI card installed. Option
96 enables the number of ISDN T1 links purchased. These MOSS options
serve all the NSUs and PRI cards in the system. If you change any of these
options, you must reset the NSU and PRI card to enable them, and you may
need to download a new IMAT database into each NSU and PRI card.
CDE programming
1. Form 53, Bay Location Assignment
- Assign a bay number to the CIM or FIM ports used to connect each
NSU or PRI card to the controller.
2. Form 01, System Configuration
Note: If you purchase a number of T1 links less than the number of T1 links
you install and program, Mitel cannot reliably predict which T1 links the
system will use after a reset. If you purchase a number of T1 links (System
Option 96) greater than the number of T1 links you install and program, the
T1 links programmed will remain consistent.