Filter
Top Products
199
Routine Maintenance
Replacing the Hard Drive or CompactFlash
Use this procedure to replace faulty internal media. To upgrade the media
in a working system, follow the procedure on page 46, “Installing a hard
drive.”
To replace the hard drive or internal CompactFlash
1. Remove the external CompactFlash card, if inserted.
2. Unplug the power cord from the controller.
3. Remove the cover.
4. If replacing the CompactFlash card, remove it, install the new one, and
then skip to step 6.
5. If replacing the hard drive,
a. Unplug the ribbon cable and the power cable from the old hard drive.
b. Remove the old hard drive by unfastening the four small border
screws. Keep the screws.
c. Replace the drive with the new one.
d. Connect the ribbon cable and power cable to the new hard drive.
Note: Use Mitel-provided CompactFlash cards and hard drives only;
those obtained elsewhere are not supported.
Note: Ensure that the jumpers on the new drive are set to the Master
setting.