Filter
Top Products
188
SX-200 ICP MX Technician’s Handbook
3. Test the setup by sending an alarm, an E911 notification, and a log to
e-mail. The messages for these events should be sent to the correct
e-mail address. (Disconnect the system from the PSTN while testing
E911.)
Programming IMAP (Standard Unified Messaging)
Programming the IMAP client
1. Form 04, System Options/System Timers
- Enable System Option 126, Email Messaging.
- (Optional) Enable System Option 137, Mark SMTP Forwarded
Voicemails as Read. If enabled, messages change from "new" to
"read" state when forwarded. Otherwise, they remain in their
original state (i.e, a "new" message will remain "new" after
forwarding). Only "new" messages flash user's MWI lamp.
2. Form 49, Voice Mail Options
- Enter the IP address of the IMAP server.
Programming voice mail to e-mail forwarding
1. Complete the IMAP programming above.
2. Form 50, Mailboxes
- In the Email subform, select a mailbox in the FWD column, then
press the UNIFIED softkey.
Note: Configure user account information, including e-mail addresses and
extension numbers, in the 6000MAS.
Example voice mail forward to e-mail message (IMAP)
-------------------------------------------------------------------
From: 106 <voicemail@do-not-reply>
Sent: Tuesday, April 13, 2004 10:03 AM
To: 107
Subject: Voicemail message from 106 <ID: 1081872898>
-------------------------------------------------------------------
This e-mail contains a voice message.
Double click on the attached file to listen.