Filter
Top Products
151
Basic Programming
Programming for the 6010 Teleworker
Solution
Requirements
Support for the 6010 Teleworker on the SX-200 ICP requires the following:
• Mitel 6000 Managed Applications Server (MAS), Release 6.0 or higher
• Mitel 6010 Teleworker Solution Blade (installs on the 6000 MAS),
Release 6.0 or higher
• a valid Service Link account
• 5020 IP, 5212 IP, 5215 IP, 5220 IP, or 5224 IP Phone (with Boot Load
5.22 or later)
• an IP Phone license for each Teleworker phone
Installation and programming
Below is an overview of the installation and programming needed to
implement the 6010 Teleworker Solution. For more information, see the
Applications & Solutions section on the Mitel Customer Documentation
website for documentation.
SX-200 ICP
• Form 09, Desktop Device Assignments
- Assign set type (5020, 5212, 5215, 5220, or 5224), extension
number, COS, COR, and name (optional) for each bay/slot/circuit
that will host a Teleworker phone.
IMPORTANT: Basic I & M certification qualifies technicians to
install a Mitel 6010 Teleworker for voice-only use. Installation
in a converged voice and data network requires Advanced
I & M certification.
Note: The 6000 MAS must be on the same VLAN (subnet) as the SX-200 ICP.
Note: Phones with low bandwidth connections should have Option 688
(IP Set Requires Compression) enabled in their Class of Service.