Filter
Top Products
174
SX-200 ICP MX Technician’s Handbook
Layer 2 Switch Settings (Example)
The following two tables show settings on a Cisco and an HP Layer 2
switch for the Configuration 1 example.
Note: These settings also apply for the other network configuration
examples.
Table 27: Cisco Layer 2 Switch Settings for All Configuration
Examples
Port Use Command
A Access port
for VLAN 1
None (by default, all ports belong to VLAN 1)
B
C Access port
for VLAN 2
L2switch(config-if)#switchport mode access
L2switch(config-if)#switchport access vlan 2
D
E Trunk port
with Dot1q for
IP Phone
L2switch(config)#interface fast 0/5
L2switch(config-if)#switchport mode trunk
L2switch(config-if)#switchport trunk encapsulation
dot1q
Table 28: HP Layer 2 Switch Settings for All Configuration Examples
Port Use Command (on HP VLAN menu)
A Access port for VLAN 1 VLAN 1 = untagged
VLAN 2 = NO
B
C Access port for VLAN 2 VLAN 1 = NO
VLAN 2 = untagged
D
E Trunk port VLAN 1 = untagged
VLAN 2 = tagged