Filter
Top Products
USER’S MANUAL
Appendix 8 – Ordering ISDN for the USA and Canada 337
PROTOCOL: National ISDN-1 (or National ISDN-2)
From AT&T 5ESS, Northern Telecom DMS100, and Siemens EWSD.
If you use IOC Capability Packages, please use Capability Package ‘S’ unless otherwise specified.
CO Values
Line Type: National ISDN-1
Bearer Service: CSD/CSV on both channels (CSD is required; CSV may be omitted if requested by user)
TEI: One dynamic per number
Terminal Type: A
101XXXX Long distance access: Yes
Turn off features such as; packet mode data, multiple call appearances, Electronic Key Telephone
Service (EKTS), shared directory numbers, accept special type of number, intercom groups, network
resource selector (modem pools), message waiting, hunting, interLATA competition, etc.
NOTE for EWSD running NI-2: Switch must be programmed CLID=DN.
Note for AT&T/Lucent 5ESS on loop extended lines: Per Lucent Technologies, REX test must be
disabled for this line using one of the following: ASDFI266 (Prohibit REX on BRI lines per office) or
ASDFI267 (Prohibit REX on BRI lines per line).
Give your customer the following information:
1) Two SPID numbers, depending upon number of active B channels
2) Two Directory Numbers
PROTOCOL: Northern Telecom DMS100 “Functional” (Custom, PVC1)
Northern Telecom DMS100 switches BCS 31 and above.
CO Values
Line Type: Basic Rate, Functional
EKTS: No
Call Appearance Handling: No
Non-Initializing Terminal: No
Circuit Switched Service: Yes
Packet Switched Service: No
TEI: Dynamic
Bearer Service: CSD/CSV on both channels (CSD is req’d; CSV may be omitted if requested by user)
Give to your customer the following information:
1) Two SPID numbers, depending upon number of active B channels
2) Two Directory Numbers