Support User Manuals

Telos Zephyr Xstream Two-Way Radio User Manual

Open as PDF

of 381

USER’S MANUAL

Section 11: THE WORKS – Detailed Menu Reference 216

SPIDError‐TheSPIDenteredfortheindicatedchannelisincorrect.Youmayhave

entereditwrong,ortheTelcomayhavegivenyouthewrongSPID(orenteredtheSPID

incorrectlyintheirswitch).

Ready–ThisindicatesthatanISDNlineispresent.Itindicatesthatallhandshakingwith

thecen

tralofficeiscompleteandthelineisreadytobeused.Note:IfReadyisdisplayed

andtheXstreamcannotmakeorreceivecallsyoumayhavetheTelcooptionset

incorrectlyoryoumayhaveomittedyourSPIDs.

Conn:xxx‐Thechannelisconnectedto"xxx"."xxx"isthecallerIDofthecalli

ngpartyif

availableforcallsoriginatedfromthefarend,orthenumberdialedforcallsoriginated

bytheZephyrXstream.

Acalltimerbelow,thelinestatus,displaysthelengthoftimethecallhasbeen

connectedinthefollowingformat:Days‐hours:minu

tes:seconds

PendingSeize‐Outgoingcallinprogress;RequestforcallhasbeensenttotheTelco

switchandZephyrXstreamisawaitingacknowledgment.

Seized‐Outgoingcallinprogress;Telcoswitchhasacknowledgedthecallrequest.

Proceeding‐Outgoingcallinprogress.Telcoswitchhasacknowledgedthecallrequest

andiswaitingforroutingi

nformationfromthenetwork.

OutgoingRing‐Outgoingcallinprogress;farendhasgeneratedacallalertsignal.

Ring:xxx‐Incomingcallfrom"xxx"hasbeendetectedandisbeingprocessed."xxx"is

thecallerIDofthecallingparty,ifavailable.

AcceptingCall‐Incomingcallisbeinganswered

Disconnecting‐Req

uesttodisconnecthasbeenmade.Awaitingacknowledgement.

Ended‐Requesttodisconnecthasbeenmadeandthecallhasbeencleared.

Inactive:TheinternalNT1hasnotinitialized.ExternalNT1(ifany)isnotactiveontheS

interface.AlsodisplayedonETS300linesthathavebeen"deactivated"orpu

ttosleep.

Notethiscaseisnotunusual,andlinesinthiscasewillreawakenwhenused.

Note,thismayalsobedisplayediftheTelcosettingintheTELmenuissetincorrectly.

i

ISDN TIP!

If you reboot the Xstream and the line status shows Ready & Ready, but you cannot make or

receive calls, check the following:

-Is the Telco selection in the TEL menu set correctly? Certain incorrect combinations may

cause a false Ready indication.

-If your ISDN protocol requires SPIDs, have you entered them in the TEL menu (See

below)?

-Is the Interface selection in the TEL menu set to ISDN? You won’t be able to place calls if

the ISDN interface is not selected.

previous next