Filter
Top Products
USER’S MANUAL
Section 12: System Functions and Remote Control 256
Name.......: micprocess
Parameter..: [<mic1..4> <VoiceL|VoiceM|VoiceH|Music|Off>]
Group......: Audio
Description: Select the processing type for the specified microphone input.
Name.......: micpan
Parameter..: [<mic1..4> <-10...+10>]
Group......: Audio
Description: Set the panning for the specified microphone input in case it is assigned to
both input channels. -10 pans to the left, 10 pans to the right, 0 pans to the center.
Name.......: micassign
Parameter..: [<mic1..4> <L|R|B|->]
Group......: Audio
Description: Assign the specified microphone input to the left, right, to both or no
input channel.
Name.......: micgain
Parameter..: [<<mic1..4>|A> <linepro|linecons|mic+30|mic+44>]
Group......: Audio
Description: Set mic board input sensitivity. If the microphone index is 'A' all in puts
will be set to the given gain.
Name.......: monimix
Parameter..: [<monitor1/2> <snd|rcv> <L|R|M|S>]
Group......: Audio
Description: Select source channel for either send or receive audio. L=left, R=right,
M=mono left+right, S=stereo.
Name.......: monipan
Parameter..: [<monitor1/2> <snd|rcv> <-10...10>]
Group......: Audio
Description: Select L/R balance for either send or receive audio.
Name.......: monibalance
Parameter..: [<monitor1/2> <-10...10>]
Group......: Audio
Description: Select balance between send and receive audio. -10 enables send audio only,
10 enables receive audio only. Applies only if both send and receive are enabled for this
monitor.
Name.......: moniassign
Parameter..: [<monitor1/2> <S|R|B|->]
Group......: Audio
Description: Switch selected monitor to send audio, receive audio or both send and
receive or off.
Name.......: monoin
Parameter..: <+|->
Group......: Audio
Description: Switch audio going to the encoder to mono or stereo.
Name.......: network
Parameter..: <isdn|v35|v35hi|ethernet>
Group......: Codec
Description: Select the network type for bitstream I/O.
Name.......: numbase
Parameter..: <bin|dec|hex|<2...16>> [def]
Group......: Misc
Description: Set default number base for number input. This affects only the current
session. If 'def' is specified then this will be the default number base for all future
sessions.
Name.......: perfo
Parameter..: [r]
Group......: Status
Description: TTYprint reatime kernel performance info and reset statistics. Optionally