Filter
Top Products
USER’S MANUAL
Section 12: System Functions and Remote Control 249
Togetalistofallavailablecommandstype: "help * <enter>” as shown below.
>>Help *
Built-in commands:
Name.......: printsender
Parameter..: -
Group......: Multicast
Description: Show all defined Stream Senders.
Name.......: startsender
Parameter..: [<Host name|IP address>] [<port>] Group......: Multicast
Description: Start an stream sender host.
Name.......: addsender
Parameter..: [<Host name|IP address>] [<port>] [<ttl>] Group......: Multicast
Description: Add an stream sender host.
Name.......: zaesin
Parameter..: <analog | conv | sync >
Group......: Zephyr-style
Description: Select AES/EBU input mode
Name.......: zaesout
Parameter..: <normal|32|44|48|ext|aesin>
Group......: Zephyr-style
Description: Select AES/EBU ouput mode.
Name.......: zanswer
Parameter..: <A+|A-
Group......: Zephyr-style
Description: Switch ISDN and phone auto-answer on/off
Name.......: zatdt
Parameter..: [auto|no|E[c]]
Group......: Zephyr-style
Description: Set RS232 to transport mode, (use '+++' or to quit') Default: off
Name.......: zbaud
Parameter..: [<300|600|1200|2400|4800|9600|19200> [1|2]]
Group......: Zephyr-style
Description: Set RS232 baudrate. The additional number of stopbits is ignored.
Name.......: zbitrate
Parameter..: <56/32|64/32|56/48|64/48>
Group......: Zephyr-style
Description: Select line Bitrate/Sample rate in kbps/kHz, default: 56kbps/32kHz
Name.......: zconn
Parameter..: <1|2> <number> or <1..50>
Group......: Zephyr-style
Description: Establish Zephyr-type ISDN connection on line 1 or 2 or activate a set up.
Name.......: zdirec
Parameter..: <line0..7> <number|->
Group......: Zephyr-style
Description: Set or delete MSN resp. DN number.
Name.......: zdisc
Parameter..: <1|2|B>
Group......: Zephyr-style
Description: Disconnect ISDN on line 1 or 2, or both
Name.......: zlevel
Parameter..: <-15 .. +4>
Group......: Zephyr-style