Filter
Top Products
USER’S MANUAL
Section 11: THE WORKS – Detailed Menu Reference 236
PP in 0 to PP in 7
End‐to‐End
Thisoptionisusedtopasscontactclosureinformationtothefarendusingthe
ancillarydatachannelpresentincertaincodecmodes(seeSections12.1,3.2&
3.4).
h
HOT TIP!
An ancillary data channel will only be present in a given transmission direction if the receive
codec is "locked" and one of the following codec modes is employed in that direction.
AAC (all modes), AAC-LD (all modes), Layer 3 (all modes) Layer 2 mono 64
Z
ZEPHYR CLASSIC VS XSTREAM COMPARISON!
NOTE:
1. The Zephyr Classic and Zephyr Express do not support Ancillary data in Layer 2.
2. In Layer 3 Zephyr Classic can send and receive ancillary data to and from a Zephyr
Xstream. Inputs 0-3 on the Zephyr correspond to Outputs 0-3 on the Xstream and vice
versa.
DialSetup0(PanicDial)
GroundinganinputsettothisoptionwillcausetheXstreamtodropanyactive
ISDNcall(s)andtoconnectasspecifiedinDialSetup0.Willremainconnected
solongastheassociatedinputremainsasserted(i.e.grounded).
h
HOT TIP!
If there are no phone numbers entered in Dial Setup 0, triggering this input will merely cause
the codec to hang up. If Dial Setup 0 includes codec information, these modes will be set as
well. See Section 4.2 (introduction to the Menu system)
DialSetup1…7
Seeabove.PerformsthesamefunctionforDialSetup1…7.