Support User Manuals

Telos Zephyr Xstream Two-Way Radio User Manual

Open as PDF

of 381

USER’S MANUAL

Section 13: Deep Tech Information and Troubleshooting 262

13.1 Accessing the Hardware

e

IMPORTANT! WARNING! DANGER!

Always disconnect AC (mains) power and Telephone Circuit Before

removing the Zephyr Xstream’s cover.

Potentially lethal voltages are inside! Failure to observe the above warning

may result in electric shock, injury or even death!

Refer all servicing to qualified personnel.

w

TO PREVENT RISKS OF

ELECTRIC SHOCK,

DISCONNECT POWER

CORD BEFORE SERVICING

The installation and servicing instructions in this manual are for use by

qualified personnel only. To avoid electric shock do not perform any ser-

vicing other than that contained in the Operating Instructions unles s you

are qualified to do so. Refer all servicing to qualified service personnel.

CAUTION

To remove the top cover:

1. Removepowerfromunit

2. Removetoplidscrews(14or18screws)usingaPhillipsscrewdriver.6

screwstop(thesewillbe1/16thinchedAllenscrewsonmodelMXP),4or6

screwsoneachside.Liftcoverstraightofftheunit.

NOTE:OntheZephyrXstreamMXPthe6screwsonthetopalsoholdthe

protectiveru

bberbumpers.Theserequirea1/16inchAllendriverto

remove.

To replace the top cover:

1. Replacethelid.IfyouhaveaZephyrXstreamMXPalignthebluebumpers

withtheircorrespondingholes.Usethe6Allenscrewsinthosepositions.

2. Fastenthelidusingth

e14or18Phillipsheadscrewsremovedinstep1.

Setting the nominal input level range (non-mixer version only)

TheXstreamcansupport+4dBu(Professional)/‐11dBu(consumer)levelsdependingonthe

LevelInSettingintheAudiomenu.ThisishowtheXstreamisshippedfromthefactory.

previous next