Filter
Top Products
2.5 INSTALLATION STEPS
38 Installation Manual
CAUTION
If the Rotary Switch is not reset to position 0 after initialisation, all programming
will be lost when the voice processor loses power!
6.
Perform Quick Setup (see Section 5 CUSTOMISING THE SYSTEM).
7.
Check Quick Setup:
• The Power Indicator on the Voice Processor should be solid.
• The screen output should be: [On Line].
If you do not see the "On Line" message, check the following:
• The line cord to the Voice Processor has 4 conductors.
• The programming on the KX-TD816, KX-TD1232 or KX-TD612 is correctly set in
System Programme [126].
• The programming on the KX-TD500 is correctly set in the 1-4 VPS (DPT) Port
Assignment screen.
8.
Set up Class of Service (COS) for each user. Customise voice prompts if necessary (see
Appendix B SYSTEM ADMINISTRATOR'S GUIDE).
9.
Perform Administrative Programming through a personal computer (see Appendix B
SYSTEM ADMINISTRATOR'S GUIDE).
Do not turn the power off while the VPS is activated so as not to cause malfunction.
To turn the power off after installing the VPS, unplug the power cord from the VPS a
few minutes after disconnecting all extension wire(s).
CAUTION