Filter
Top Products
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
252 Installation Manual
B6.6 System Caller Name Announcement
Up to 120 Caller ID numbers can be assigned to announce prerecorded Caller ID caller names
when extension users listen to messages from the assigned numbers left in their mailbox.
Extension users can also hear caller names when the VPS forwards calls from the assigned
numbers to them (Caller ID Screening). The recorded caller names will also play when the
callers use the Intercom Paging features; the recorded names will be added to the end of the
page.
The Caller ID Screening feature is enabled or disabled in the COS (Class of Service) settings.
This feature is also enabled by selecting "Call Screening" in 4.1 Call Transfer Status in the
Subscriber’s Guide.
The Intercom Paging feature is enabled by selecting "Intercom Paging" in 4.1 Call Transfer
Status, and/or in 4.4 Message Reception Mode in the Subscriber’s Guide.
The Message Manager is responsible for recording System Caller Names.
System Caller Name Announcement-Enter
Position of
"AM/PM" in
Time Stamp for
User 1 Prompt
1. Before
2. After
3. 24-h
(After)
This parameter setting is functional only when User 1 or
User 2 Prompts are in use. This parameter specifies the
following:
Position of
"AM/PM" in
Time Stamp for
User 2 Prompt
1. Before—the VPS announces "AM/PM" before the time
(e.g., P.M. 3:42).
2. After—The VPS announces "AM/PM" after the time
(e.g., 3:42 P.M.).
3. 24-h—the VPS announces the time in 24-h format
(e.g., 15:42).
Note: When System Prompts are in use, the parameter is
set to "After".
To access the proper menu for System Caller Name Announcement, follow the
menu path as shown:
System Administration Top Menu-1-5-6
To access the proper menu for System Caller Name Announcement-Enter, follow
the menu path as shown:
System Administration Top Menu-1-5-6-1-Caller ID List No.(1-120)
Table B-26
Parameter Value Range
(Default)
Description/Function