Filter
Top Products
B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS
Installation Manual 269
Inband Signaling Parameters
Use these parameters if the PBX sends touchtones to the VPS to indicate the state of a call
(busy, answered, disconnected, etc.). The integration mode must be set to "Inband". If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
The following parameters can be programmed using "0-9", " ", "#", and "A-D".
Alternate
Extension
Transfer
Sequence
(FX)
The VPS performs this sequence when transferring calls
to extensions in the Alternate Extension Group.
Reconnect
Sequence on
Busy
(FWW)
If an extension is busy, this sequence allows the VPS to
reconnect to the caller.
Reconnect
Sequence on
No Answer
(FWW)
If the extension does not answer, this sequence allows the
VPS to reconnect with the caller.
Reconnect
Sequence on
Refuse Call
(FWW)
The VPS performs this sequence to retrieve a call placed
on hold after the extension (in the Call Screening mode)
has refused to accept it.
Light-On
Sequence for
Message
Waiting Lamp
(None)
This is the dialling sequence that the VPS must perform to
enable the Message Waiting Lamp at an extension.
Light-Off
Sequence for
Message
Waiting Lamp
(None)
This is the dialling sequence that the VPS must perform to
disable the Message Waiting Lamp at an extension.
Call Waiting
Sequence
(None)
The VPS carries out this sequence when performing call
waiting if the extension being called is busy.
Release
Sequence for
Call Waiting
(None)
The VPS performs this sequence to release call waiting.
To access the proper menu for Inband Signaling Parameters, follow the menu path
as shown:
System Administration Top Menu-1-6-3-2
Table B-42
Parameter Value Range
(Default)
Description/Function