Filter
Top Products
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Installation Manual 261
Other Parameters-Fax Management
You can program the VPS to automatically forward incoming fax calls to a fax extension. You
can specify a maximum of 2 fax extensions as the destination for the Automatic Fax Transfer.
Table B-34
Parameter Value Range
(Default)
Description/Function
Intercom
Paging
Sequence
Up to 12 digits con-
sisting of 0-9, , #
and special codes
(FXW)
Specifies the intercom paging sequence required by
the PBX. This can be programmed using up to 12 of
the following 8 letters and 12 dial codes.
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialling
A: Answer
1-9, 0, , #: Dial Digits
Release for
Intercom
Paging
Up to 12 digits con-
sisting of 0-9, , #
and special codes
(FW)
Specifies the intercom paging release code required
by the PBX. This can be programmed using up to 12 of
the 8 letters and 12 dial digits as specified above.
No Answer
Time for
Intercom
Paging
1-30 s
(5)
Specifies the length of time (in seconds) the VPS must
wait before concluding Intercom Paging when there is
no answer.
The VPS will return to the caller if the paged party does
not respond before this timer expires.
Announcement
Repeat Cycle
1-3 times
(1)
Specifies the number of times to announce the
intercom page.
Example:
"I have a call for (mailbox owner’s name)".
Intercom
Paging Retry
1-10 times
(2)
Specifies the number of times to retry paging when the
paging destination is busy or if there is no answer.
Note: This setting applies only when the subscriber
has enabled "Intercom Paging" in Incomplete Call
Handling Status.
Paging Code
for Group 1-16
Up to 12 digits
consisting of
0-9, ,# for each
group
(None)
Specifies the intercom paging access code required by
the PBX.
Note: The Intercom Paging Group Number available
for each subscriber is determined on a COS-by-COS
basis.
Paging Code
for All Groups