Filter
Top Products
5.2 PORT SETTING OPTIONS
116 Installation Manual
This also allows an extension to be assigned as the fax manager to be notified on incoming
faxes.
Disconnect Parameter (1-5-7-9)
Determines how many seconds of silence the VPS allows during a caller’s message before
disconnecting the call.
RS-232C Settings (1-6-1)
Allows the System Administrator to change the baud rate, parity bit, etc.
Port Setting (1-6-2)
Only to be used when connecting the VPS to a PBX other than a KX-T series PBX. Use the
CPC control of the PBX for normal disconnect problems.
Dialing Parameters (1-6-3-1)
These parameters are set automatically when Quick Setup is conducted.
Most of the settings will be left unchanged. The only setting that will be changed quite often is
the Transfer Sequence for the operator or the extension. By default, it is set at FX on DPT
Integration and FTX for Inband Integration. In other words, the voice processor dials the flash
(recall), waits for intercom tone and dials the extension number. By default, the VPS will stay
on the line to monitor the status of the call. If the extension user answers, the voice processor
will announce "you have a call" prior to releasing the call. This can be alleviated by adding the
letter "A" or "D" to the sequence. "A" stands for answer; the call will be transferred without the
announcement "you have a call". For a blind or unscreened transfer, add the letter "D" for
disconnect.
5.2.3 Custom Service Programming
After you have finished constructing the tree, enter the System Programming Custom Service
Settings Menu.
Access the Custom Service Setting Menu through the following sequence:
System Administration Top Menu:
The system then asks what Custom Service number you want to edit. Enter the desired
number (1-100).
The Custom Service screen is displayed:
Enter The Number: = 1 (Program)
Enter The Number: = 4 (Service Setting)
Enter The Number: = 2 (Custom Service)