Filter
Top Products
7.2 UTILITY COMMANDS
Installation Manual 161
7.2.19 Touchtone Information Display (PUTD)
Use the PUTD command to display the touchtones the VPS receives and sends.
In addition to the touchtones, the following will be displayed—the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting of this mode for all ports is "OFF".
To change the mode from "PUTD" to "OFF", Type PUTD again.
Note
"*" means "enable" for the port. "0" means "disable" for the port.
To set the mode for only 1 port, Type PUTD and the port number.
$ LMON
No.:
1: Ready
2: Ready
3: Error
4: Error
5: Error
6: Error
Status
No.:
7: Error
8: Error
9: Error
10: Error
11: Error
12: Error
Status
$ PUTD
Target Port : * * * * * * * * * * * *
Don't leave enabled after troubleshooting.
$
$ PUTD
Target Port : 0000 0000 0000
Don't leave enabled after troubleshooting.
$
$ PUTD 1
Target Port : 0000 0000 000*
Don't leave enabled after troubleshooting.
$