Filter
Top Products
B3 SYSTEM ADMINISTRATION—SETTING COS (CLASS OF SERVICE) PARAMETERS
Installation Manual 221
Authorization
for External
Message
Delivery
1. Yes
2. No
(No)
If set to "Yes", subscribers are able to utilise the External
Message Delivery feature. The sub-parameter to be set
is Prompt Mode. If set to "No", sub-parameter cannot be
assigned.
Prompt Mode
1. System
2. User 1
3. User 2
4. Selective
(User 1)
When an external message is delivered, the receiver will
be greeted by the VPS in the specified language
(prompt). However, if "Selective" is enabled, then the
receiver has a choice of prompts. See related
explanation in "Incoming Call Service Prompt" in Table
5-5 in 5.3.1 Port Service Menu.
Note: When "Selective" is enabled and the receiver uses
a rotary telephone, the no-entry selection is specified by
"Prompt for Rotary Callers" in Table 5-5 in 5.3.1 Port
Service Menu.
Authorization
for Auto
Forwarding
1. Yes
2. No
(No)
If set to "Yes", the VPS automatically forwards
messages that have not been accessed for a specific
length of time to another mailbox. The sub-parameters to
be set for this feature include Mailbox Number, Delay
Time, and Forwarding Mode. If set to "No", sub-
parameters cannot be assigned.
Mailbox
Number
2-5 digits
(None)
Specifies the mailbox to which the messages will be
forwarded.
Note: The numbers of the System Group Distribution
List cannot be specified as the destination.
Delay Time
(h) (min)
00:05 to 99:59
(00:30)
Specifies the length of time in hours and minutes that the
VPS must wait before forwarding unretrieved messages.
The maximum delay time is 99 h, 59 min.
Note: The delay time must be less than the New
Message Retention Time, or else messages will be
deleted before being forwarded.
Forwarding
Mode
1. Copy
2. Move
(Move)
Specifies if forwarded messages are to be retained in the
original mailbox. When set to "Copy", copies of the
messages are retained in the original mailbox after
forwarding. When set to "Move", messages are
forwarded to the receiving mailbox and are not retained
at the original location.
Table B-7
Parameter Value Range
(Default)
Description/Function