Filter
Top Products
7.2 UTILITY COMMANDS
152 Installation Manual
Note
The following tables display and explain the errors that the system can identify.
* = port number (1-12)
Examples of a terminal display when errors are generated:
Table 7-2 Device Error Log Indications
Indication Meaning
CPU MEM-GET CPU board software memory acquisition error.
CPU board is short of memory temporarily
because of too much traffic.
CLOCK Clock access error. Clock IC is out of order.
Check the hardware.
DISK DATA R/W (xx:yyyy) HDD access error. If there is a sector that often
causes errors, check the disk.
xx : IDE error code
yyyy : read/write error sector number
DSP* SCAN DSP-SCAN error. DSP is out of order. Check the
hardware.
DSP* FIFO DSP/FIFO error. During the system is handling
calls, there was a temporary problem with the DSP
and FIFO memory.
CPU APPLICATION (x) Application error. While the system is handling
calls, temporary application error occurs.
x: port number
Table 7-3 Error Indications at System Startup
Indication Meaning
ROM ERROR: Sum Error!! ROM checksum error.
DISK ERROR: Initialize Error!! HDD initialisation error.
DISK ERROR: No System!! No system HDD present.
DISK ERROR: Program Load Error!! Programme could not be loaded from system
HDD.
DISK ERROR: Program Sum Error!! Checksum error in programme loaded from
system HDD.
$ ELOG
DEVICE ERROR TIME
14-JUL 2:00 PMMEM-GET1. CPU
14-JUL 2:00 PM2. CLOCK
14-JUL 2:00 PMDATA R/W (xx:yyyy)3. DISK
14-JUL 2:00 PMSCAN4. DSP*
14-JUL 2:00 PMFIFO5. DSP*
14-JUL 2:00 PMAPPLICATION (x)6. CPU
* = port number (1-12)