Filter
Top Products
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
256 Installation Manual
Table B-29
Parameter Value Range
(Default)
Description/Function
Number of
Digits
to Access
Outside Line
0-8 digits
(1)
Specifies the number of digits necessary to access an
outside (CO) line.
Example:
If the PBX requires callers to dial "9" to access an
outside (CO) line, this parameter should be set as "1".
This enables the system to recognise that an outgoing
call setup sequence is completed once the initial "9"
has been dialled (9-123-4567). The full sequence is
therefore: 9-(outgoing call setup sequence)-123-4567.
The VPS can discriminate between local and long
distance calls and can report outgoing calls and calling
times for billing purposes on periodic port usage
reports.
Call Transfer
No Answer
Time
10-60 s
(20)
Specifies the length of time that the VPS must wait
before retrieving the transferred call when there is no
answer at the destination extension.
Note: Make sure that the duration of Call Transfer No
Answer Time is longer than the duration of Call
Forwarding No Answer Time at the PBX. Otherwise,
the PBX may forward the call (transferred by the VPS)
immediately to its destination without leaving enough
time to answer the call.
Outgoing Call
No Answer
Time
10-90 s
(30)
Specifies the length of time that the VPS must wait
before concluding that there is no answer at the
outside number called.
Pause Time 1-9 s
(2)
Specifies the pause time between dialled digits.
Outgoing Call
Setup
Sequence
Up to 12 digits
consisting of
0-9, , #, F, R, S, T,
W
(T)
Specifies the sequence of codes used by the VPS
when calling an outside (CO) line. You can set up to 12
digits. The default value is "T". "T" indicates that the
system will dial the telephone number only after
detecting a dial tone.
Example:
9W = (9) - 2-s wait - dial telephone number. "9" is the
outside (CO) line access number.
F: Flash (Recall)
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
1-9, 0, , #: Dial Codes