Filter
Top Products
26 Chapter 2 About setting up Call Center
P0605665 03
Using the dialpad
The buttons on your display telephone dialpad act as both numbers and letters. Each button
represents a number and letters of the alphabet.
Letters and numbers on the dialpad
The display can show up to 16 characters. The prompt remains on the display if you enter fewer
than ten characters. If you enter information where the prompt and the information is fewer than
16 characters, you can see both the prompt and the information you enter.
The prompt disappears for these command line prompts:
•Name:
•Log:
•Dest ph:
To enter a character
press the dialpad button that represents the letter or number. Press the
button again to see the next letter or number.
To accept a character
press £ or press another button. When you press another button, the
cursor advances and the display shows the first character on the new
button.
To delete a character
press the BKSP display button.
⁄ 1 ’ - ¤ A B C 2 a b c ‹ D E F 3 d e f
› G H I 4 g h i fi J K L 5 j k l fl M N O 6 m n o
‡ P Q R S 7 p q r s ° T U V 8 t u v · W X Y Z 9 w x y z
• Quit ‚ Q Z Zero q z £ Accepts the displayed letter
enters a comma (,)
This is an example of a display with fewer than 16 characters, where
the command line prompt remains on the display.
This display shows the Name: command line prompt.
When you begin to enter the last name, the Name: command line
prompt disappears. For example, if you enter the name Partridge, you
press ‡ for P, and the display drops the Name: prompt.
Although the name is only nine characters long, the command line
prompt is not shown on the display after you enter the entire name.
Pswd:1111
OTHR RETRY OK
Name:
RETRY BKSP OK
P
RETRY BKSP OK
PARTRIDGE
RETRY BKSP OK