Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 212 [DCS / Compact II] (Page 1 of 1)
MMC: 212 ALARM RINGING STATION
DCS
33
CI
77
CII
33
816
77
408i
77
408
77
Used to determine which devices will be alerted when an alarm sensor is activated.
Device DCS Compact II
Station 201–349 201 - 308
Station group 500–529 500 - 519
The above devices will ring like a doorphone and follow the door ring time-out. When ringing,
display keysets show the display assigned in MMC 213, Alarm Message. The bottom line of the
keyset display gives an option to clear the alarm. Ringing initiated by an alarm sensor is an-
swered by going off-hook and on-hook again at a ringing keyset. If a device such as Ring Over
Page or a common bell is the only device assigned to ring, it may be answered by assigning a
direct pickup key with this device as the extender. If the alarm is unanswered by the door ring
time-out, ringing will cease but the display will remain until cleared by dialling the alarm clear fea-
ture code (57) and passcode (default 8765).
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Open programming and select 212
Display shows first sensor (3501 on DCS system or
351 on Compact II system)
[3
501]ALARM RING
D:500 N:500
2. Dial sensor number (e.g., 3502 or 352)
OR
Use UP or DOWN to scroll through sensor numbers
and press RIGHT soft key to advance cursor
[3502]ALARM RING
D:500 N:500
3. Enter valid ring destination for day (e.g., 205)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
Select night destination in the same way
[3
502]ALARM RING
D:205 N:500
4. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC
Default Data: All sensors ring 500 day/night
Related Items: MMC 213 Alarm Message