Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 804 (Page 1 of 3)
MMC: 804 SYSTEM I/O PARAMETER
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Provides a means of setting parameters for the system I/O ports to work with one of the follow-
ing:
• a personal computer (PC)
• Station Message Detail Recording (SMDR)
• UCD statistics report/periodic UCD information (except 408/408i)
• CTI (TSAPI) interface (DCS and Compact II only).
All systems have two I/O ports (Ports 1 and 2), except 408/408i which have one I/O port (Port 1).
Programming can be accomplished easily, using the tables below to customise any I/O port.
PARAMETER OPTIONS
Dial 0 Service Type of Service
Dial 1 Baud Rate Speed
Dial 2 Char Length Character Length
Dial 3 Parity Parity Bit
Dial 4 Retry Count Number of Retries
Dial 5 Stop Bit Stop Bit
Dial 6 Wait Time Message Wait Time
Dial 7 DSR Check DSR Check on/off (Compact II, 816 and 408/408i only)
or
SIM Pair No. of the station connected to the Serial Interface Module
(SIM) (DCS only)
SERVICE TYPE
Each port can be set to one of the following service types. Note that the services available depend on
the type of system being programmed. For example, DCS and CII systems provide all the following
services while 408/408i systems provide PC-MMC and SMDR only.
Type Description
PC-MMC PC application
SMDR SMDR report (call logging)
UCD REPT UCD report on request by the
supervisor, or daily
UCD/SMDR Both SMDR and UCD report will
be generated
CTI Dedicated Switch Link Interface
CTI/SMDR CTI and SMDR
CTI/UCD CTI and UCD
CTI/S/U CTI, SMDR and UCD
VM TRACE Voice Mail monitoring
NOT USE Not used