Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 715 (Page 1 of 2)
MMC: 715 PROGRAMMED STATION
MESSAGE
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Allows a custom message, up to 16 characters, to be programmed. There are 20 messages al-
lowed in total (01–20). Messages 01–10 are pre-set (see default data) but can be changed by de-
leting and/or typing in new text. Messages 11–20 are blank by default (“EMPTY MESSAGE” may
be displayed if one of these is selected, or the display is blank).
Messages are written via the keypad. Each press of a key selects a character. Pressing a differ-
ent key moves the cursor to the next position. For example, if the message is “In the Showroom,”
press key number “4” three times to get the letter “I.” Then press key number “6” twice to get the
to move the cursor right. Continue selecting characters from the
keypad to complete your message. Press the programmable ”A” key to toggle between upper
and lower case text.
Tip: When the character you want is on the same key as the previous character you typed in, press the UP
key to move the cursor to the right, then select the character.
The # key can be used for the following special characters (in sequence of key presses):
#
space
& ! : ? . , % $ - < > / =
[ ] @ ^ ( ) _ + { } | ; "
→
`
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
“A” Key #19 (24B keysets) or key #7 (12B keysets) or key #1 (6B key-
sets) toggles upper case and lower case text.
ACTION DISPLAY
1. Open programming and select 715
Display shows
PGM.MESSAGE(01)
IN A MEETING
2. Enter index number (e.g., 11)
OR
Press UP or DOWN arrow to make selection and press
RIGHT soft key to move cursor
PGM.MESSAGE(11)
EMPTY MESSAGE