Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 716 (Page 1 of 2)
MMC: 716 UK LCR OPTION
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Before using this MMC, run MMC 812 to make sure the correct country option (“UK”) has
been selected.
MMC 716 provides UK LCR options.
0 NETWORK CODE Provides secondary network access code when the call is
routed to the secondary network. 16 entries maximum
(each 10 digits maximum in length).
1 PIN CODE Assigns PIN code used when the call is routed to secon-
dary 131 Cable & Wireless network.
2 CCC OPTION Selects Call Cost Option and is related only to 131 Cable
& Wireless service.
3 STATION PIN NO Assigns individual users to selected PIN codes in the sys-
tem.
Note: The second entry may be selected as a primary secondary network. By default, this is 132 (Cable &
Wireless Digital Access). If dialled digits are not matched to the entry in the LCR DIGIT TABLE (MMC 710)
and start with 0, the network code in the second entry will be dialled out by the system prior to transmitting
dialled digits.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Open programming and select 716
Display shows
N
ETWORK CODE
01:
2. Dial item number (e.g., 1)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key.
P
IN CODE
1:
3. Enter index number (e.g., 3)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key
OR
Press LEFT soft key to return to step 2
PIN CODE
3:
4. Enter the desired access via dial keypad and press
RIGHT soft key to enter and return to step 3
PIN CODE
3: QQQQQQ
5. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC