Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 806 (Page 1 of 2)
MMC: 806 CARD PRE-INSTALL
DCS
33
CI
33
CII
33
816
33
408i
77
408
77
Allows the pre-programming of a slot for a specific card. For example, after the system is in-
stalled and a new card is added, running this program causes the system to accept the card for
what it is and not for what it is not.
The procedure differs slightly for each type of system, as described below.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
n DCS PROCEDURE
ACTION DISPLAY
1. Open programming and select 806
Display shows
C1–01 :INSTALL
PRITRK →PRITRK
2. Enter cabinet number (e.g., 3)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor
C3–01 :INSTALL
PRITRK →PRITRK
3. Enter slot number (e.g., 5)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to return to step 2
C3–05 :INSTALL
DLI → DLI
4. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC
n COMPACT II PROCEDURE
ACTION DISPLAY
1. Open programming and select 806
Display shows
O.SLI SLOT
O.2SLI →O.2SLI
2. Press UP or DOWN key to select slot number
EXP.1 SLOT
6DLI →8DLI
3. Press RIGHT soft key to change previous card type
EXP.1 SLOT
8DLI →8DLI
4. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC