Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 420 [DCS / Compact II] (Page 1 of 1)
MMC: 420 PRI OPTION
DCS
33
CI
77
CII
33
816
77
408i
77
408
77
Allows the system DDI/NORMAL access and sets dial sending mode (DLSEND) on an individual
port basis to OVERLAP or ENBLOCK. However, if you change the dial sending mode of one port,
all other ports must be set to the same dial sending mode. If your PRI line is not registered for
DDI service at the Central Office, you can use NORMAL service (e.g. subaddress or normal trunk
incoming service). If you set PRI MODE to DDI, you can service DDI (Direct Dial Inward) to a spe-
cific station or station group according to DDI NUMBER TABLE.
There is also a CHANNEL ANY option. If set to YES, when a call is initiated the channel used is
specified by the network; if set to NO, when a call is initiated the DCS/Compact II will specify
which channel to use.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Open programming and select 420
Display shows
[7
01] PRI OPTION
CHANNEL ANY:YES
2. Dial PRI trunk number (e.g. 704)
OR
Press UP or DOWN key to select the port
Press the RIGHT soft key to move the cursor
[704] PRI OPTION
CHANNEL ANY:YES
3. Press UP or DOWN key to make selection (CHANNEL
ANY, PRI MODE or DLSEND) and press RIGHT soft
key to move the cursor
[704] PRI OPTION
DLSEND : OVERLAP
4. Use UP or DOWN key to make selection
and press RIGHT soft key to return to step 2
[704] PRI OPTION
DLSEND : ENBLOCK
5. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC
Default Data: CHANNEL ANY: YES
PRI MODE: DDI
DLSEND: OVERLAP
Related Items: MMC 418 Card Restart
MMC 406 Trunk Ring Assignment
MMC 714 DDI Number and Name Translation