Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 722 (Page 1 of 3)
MMC: 722 STATION KEY PROGRAMMING
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Used to customise programmable keys on individual keysets and add-on modules (AOMs). All
systems are provided with default functions for some keys to provide basic operation. For exam-
ple, keys 1 and 2 are set as CALL keys by default because it is recommended that these keys
should always function as CALL keys (but see Note, below). Other keys can be programmed as
described here. You can use the UP and DOWN keys to scroll through the selectable functions
when programming keys (see table at the end of this MMC).
Functions can also be entered via the dial keypad. For example, to assign the OHVA function,
key number 6 can be pressed three times. If the BOSS function is required, press 2 twice for the
first letter B, and then use the UP or DOWN key to change the selection from BARGE to BOSS.
Note: 408/408i systems do not support AOMs and default key functions are different from other systems.
For example, keys 1 and 2 are not set as CALL keys by default as these are not required.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Open programming and select 722
Display shows
[2
01] KEY (MAST)
01:CALL1 →
OR OR
For 408/408i systems, display shows
(but the programming procedure is the same
as follows)
[2
1] KEY PROG
01:DT71 →
2. Enter station number (e.g., 205)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key
[205] KEY (MAST)
01:CALL1 →
3. If you have a 408/408i system, or if selected station has
no AOM pair, go to step 4
Enter 0 for MAST, 1 for AOM1 or 2 for AOM2.
OR
Press UP or DOWN key to make selection and press
RIGHT soft key
[205] KEY (M
AST)
01:CALL1 →
4. Enter key number (e.g., 18)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key
OR
Press programmable key
[205] KEY (MAST)
18:NONE →_