Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 419 (Page 2 of 3)
Ports Programmed as "STATION" in MMC 423
Display shows "BRI-STN". Items to select include some or all of the following: CHANNEL ANY,
POWER FEED (see note) and BRI CODING.
• CHANNEL ANY
(See above.)
• POWER FEED
This field determines if power to a BRI access will be supplied (YES or NO).
Note:
1. Any change to The Power Feed option is effective only after restarting the BRI card. Use MMC 418 to
restart the card.
2. Only DCS (excluding Compact I) andCompact II systems provide a Power Feed option to the S0 In-
terface. (See Table 1 in the S0 Overview section of this manual (Part 3, Special Applications).)
• BRI CODING
A-LAW or U-LAW (A-LAW in UK)
In BRI-STN, options DLSEND and BRI MODE are not included because the system uses implicit data
for these: enblock for DLSEND and P-MP for BRI MODE.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Open programming and select 419
Display shows
[701] BRI-TRK
CHANNEL ANY : YES
OR
[701] BRI-STN
CHANNEL ANY : YES
2. Dial BRI trunk number (e.g. 703)
OR
Press UP or DOWN key to select the port
For TRUNK ports (TRK), go to step 3.a
For STATION ports (STN), go to step 3.b
3.a Display is as shown for TRUNK ports
Use the RIGHT soft key to position the cursor under
CHANNEL ANY
[703] BRI-TRK
CHANNEL ANY : YES