Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 800 (Page 2 of 2)
4. Press SPEAKER to advance to MMC entry level
801:TEC.PASSCODE
SELECT PROG.ID
5. Enter the MMC required and begin programming.
Follow the instructions for that MMC.
Disabling (Closing) Programming Mode
If you wish to immediately close programming mode when you have finished programming:
§ Return to MMC 800. The display shows that programming is enabled.
§ Use the UP or DOWN key to select DISABLE and press TRSF to exit.
If you do not close programming using MMC 800, programming mode will be automatically disabled
if you do not carry out any programming tasks within the time set in the system timer KMMC LOCK
OUT (see MMC 501, System-Wide Timers).
Default Data: DISABLE (closed)
Passcode=4321
Related Items: None