Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 705 (Page 1 of 2)
MMC: 705 ASSIGN SYSTEM
SPEED DIAL
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Allow you to assign system speed dialling numbers. The number of entries available for pro-
gramming is 500 (DCS and Compact II), or 300 (816), or 200 (408/408i)—see MMC 606, Assign
Speed Block. Each speed dial number consists of a trunk or trunk group access code (e.g. 9) fol-
lowed by a separator (–) and up to 24 digits to be dialled. These dialled digits can be 0–9, Q and
#. If the system recognises a valid trunk or trunk group access number, it will automatically insert
the separator.
System speed dials are numbered as follows:
DCS 500–999
Compact II 500–999
816 500–799
408/408i 500–699
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPEAKER Used to store data and advance to next MMC
HOLD Used to clear previous entry
“B” Used to insert a flash code "F"
”C” Used to insert a pause code "P"
”D” Used to insert a pulse/tone conversion code "C"
”E” Used to mask/unmask following digits - shows as "[" or "]"
”F” Used to toggle to MMC 706 and enter name for speed dial no.
Keys “A” to “F” are keys #19 to #24 on a 24B keyset, or keys #7 to #12 on a 12B keyset, or
keys #1 to #6 on a 6B keyset
ACTION DISPLAY
1. Open programming and select 705
Display shows
SYS SPEED DIAL
500:
2. Enter the speed dial required (e.g., 505)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to move cursor
SYS SPEED DIAL
505:
3. Enter access code (e.g., 9) plus the phone number up
to 24 digits (digits will scroll under)
SYS SPEED DIAL
505:9–121223456789
4. Press “F” key to toggle to MMC 706 (step 3) to enter a
speed name for this number
OR
Press RIGHT soft key to return to step 2 to enter
another speed dial number
SYS SPEED NAME
505:_