Filter
Top Products
DCS MMC PROGRAMS
COMBINED PROGRAMMING MANUAL NOVEMBER 2001
MMC 726 (Page 1 of 3)
MMC: 726 VM/AA OPTIONS
DCS
33
CI
33
CII
33
816
33
408i
33
408
33
Provides a flexible means of setting in-band signalling for voice mail or auto attendant parame-
ters. There are eight main options for programming and several sub-options to customise the
application. Simple YES/NO, numeric and alpha characters are required for setting VM/AA.
The following options may be selected for VM/AA operation:
0 EXT FOR DN1 DTMF information for the station that called the VM/AA
port station which is forwarded to VM/AA port.
1 TRK FOR DN1 DTMF information for the trunk that called the VM/AA
port.
2 EXT FOR DN2 DTMF information for the station that originated the call
to a station which is forwarded to a VM/AA port.
3 TRK FOR DN2 DTMF information for the trunk that called a station for-
warded to a VM/AA port.
4 SEPARATOR In cases where DN2 is used, this specific digit is sent
between the DN1 and the DN2 information. Both DN1
and DN2 must be set to YES for SEPARATOR to be sent.
5 DISCONNECT SIGNAL This signal is sent when the calling station or C.O. line
hangs up.
6 CALL TYPE ID Under this VM/AA option are several customising appli-
cations:
0 DIRECT CALL A call originating directly from another station in the sys-
tem.
1 ALL FWD CALL This indicates that a call was forwarded to the VM/AA
port from a station with CALL FORWARD ALL set.
2 BSY FWD CALL This indicates that a call was forwarded to the VM/AA
port from a station with CALL FORWARD BUSY set.
3 NOA FWD CALL This indicates that a call was forwarded to the VM/AA
port from a station with CALL FORWARD NO ANSWER
set.
4 RECALL A call is recalling the VM/AA port after being transferred
and not answered.
5 DIR TRK CALL A C.O. call has gone directly to VM/AA (e.g., trunk 717
DIL to VM/AA).
6 OVERFLOW A call has OVERFLOWED to the VM/AA port from a sta-
tion group.
7 DID CALL A DDI call has called the VM/AA port.
8 MESSAGE CALL A message button or message reply feature code has
been used to call the VM/AA port.
7 PROGRESS TONE ID DTMF digits can be sent in place of normal system
tones. Digits can be assigned to the following tones: