Filter
Top Products
● If the user selects <Enable options>,
the system incorporates the changes
requested and displays the message DISCONNECTED. If Autobaud is off, the
user must now press BREAK to return to Command Mode. If Autobaud is on, the
user must press BREAK and RETURN to return to Command Mode.
Note: If a user attempts to enable options during a
“SAVE” operation by the system
administrator, the message “options changed FAILED” will be displayed. The user will
be returned to the top level of the Command Mode menu, and all change requests
discarded. After waiting a few minutes, the user may try again to change his/her data
port parameters.
Considerations
For those cases where a data terminal user accesses various data endpoints, each requiring
option changes, the User Changeable Options feature simplifies the process of administering
the data port to allow data call setup.
A system administrator is not required to enter each
change.
Interactions
● Expert Mode: See the Expert Mode feature description for an abbreviated method
of accessing Command Mode menus.
Administration Requirements
● Data Port
A data port must be administered to allow the terminal user to change options from
the Command Mode menu.
If permission is denied, the user may view the current
option settings but not change them.
● AT&T STARLAN NETWORK Access
The User Changeable Options feature is not available for ports administered as
STARLAN INTERFACE ports. Refer to the “STARLAN NETWORK Access” feature
description for additional information.
Hardware Requirements
None.
2-257