Filter
Top Products
Programming Procedures
Program mode may be entered either by dialing a code (#4) or by moving the Test/Program
switch to P (on voice terminals so equipped). If the code is used to enter program mode, the
terminal remains in program mode until the user goes on-hook or a timeout occurs. If the
switch is used to enter program mode, the terminal remains in program mode until the
switch is returned to the midpoint between P and T; the system will send a single-ring
reminder every 60 seconds until the switch is repositioned.
Programming a number always removes the number that was previously stored in the same
location. If a user wants to remove an old number and
not replace it with a new one, “ 0“
should be entered in place of the number to be programmed.
To Program a Number by Using a Code:
1. Lift the handset and listen for dial tone.
2. Dial #4.
3. Dial the number you wish to program.
4. Either:
—
press the FLEX DSS or REP DIAL button,
or
—
dial the Personal Speed Dialing code (#20 -#26)
to indicate where this number should be stored.
5. Listen for confirmation tone and dial tone.
6. Hang up.
To Program a Number by Using the Switch:
1. Slide the switch on the left side of the voice terminal to P.
2. Lift the handset and dial the number you wish to program.
3. Either:
—
press the FLEX DSS or REP DIAL button,
or
—
dial the Personal Speed Dialing code (#20-#26)
to indicate where this number should be stored.
4. Listen for confirmation tone and dial tone.
5. Hang up.
6. Slide the switch back to the midpoint between P and T.
2-196