Filter
Top Products
11-3
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.5 (SIP)
OL-20861-01
Chapter 11 Monitoring the Cisco Unified IP Phone Remotely
Enabling and Disabling Web Page Access
–
Status Messages—Displays up to the 10 most recent status messages that the phone has
generated since it was last powered up. For more information, see the
“Device Logs” section on
page 11-11.
–
Debug Display—Displays debug messages that might be useful to Cisco TAC if you require
assistance with troubleshooting. For more information, see the
“Device Logs” section on
page 11-11.
• Streaming Statistics—Includes the Audio and Video statistics, Stream 1, Stream 2, Stream 3,
Stream 4, Stream 5 and Stream 6 hyperlinks, which display a variety of streaming statistics. For
more information, see the
“Streaming Statistics” section on page 11-11.
Enabling and Disabling Web Page Access
For security purposes, access to the web pages for a phone is disabled by default. This prevents access
to the web pages that are described in this chapter and to the Cisco Unified Communications Manager
User Options web pages.
To enable access to the web pages for a phone, follow these steps from Cisco Unified Communications
Manager Administration.
Procedure
Step 1 Choose Device > Phone.
Step 2 Specify the criteria to find the phone and click Find, or click Find to display a list of all phones.
Step 3 Click the device name to open the Phone Configuration window for the device.
Step 4 Scroll down to the Product Specific Configuration section. From the Web Access drop-down list, choose
Enabled.
Step 5 Click Apply Config.
Note Some features, such as Cisco Quality Report Tool, do not function properly without access to
the phone web pages. Disabling web access also affects any serviceability application that relies
on web access, such as CiscoWorks.
To disable web page access if it has been enabled, see the preceding steps about enabling access. Follow
the same steps, but choose Disabled in Step 4 to disable the web page.
Configuring the Cisco Unified IP Phone to use HTTP/HTTPS Protocols
The Cisco Unified IP Phone can be configured to use:
• HTTPS protocol only
• HTTP or HTTPS protocols
If your Cisco Unified IP Phone is configured to use the HTTP or HTTPS protocols (the second case
above), use http://<IP_address> or https://<IP_address> for the phone’s web access.